Instruction:

The WTS Transponder is compatible with all RC System including RC Version 4 Decoders with Firmware 4.4 or lower.

Operation is purely lap counting and timing using its 7 DIGIT ID number.

The Transponder is ready to be used right away simply by connecting to a Battery or plugging into a free Receiver Channel or BATT Socket.

WTS Power Cable can be easily replaced. Preheat black part of Transponder to 80 degree (Celsius) and slowly remove PCB from Case. Solder new Cable to PCB pads. Be sure to respect the polarity. Insert PCB again into the Case. Use Hot Glue to close the Case.